Aluminum radiator RPG Racing / radiator grille for Yamaha Aerox

Especially for the Yamaha Aerox, there is probably no better known tuning part than our RPG radiator grille, which was developed specifically for the Aerox / MBK Nitro. With our water cooler, the optimal temperature is always guaranteed with every setup and in every weather .

Improvements compared to the original

With a brutal 2320cm³ cooling volume, no one is guaranteed to be disappointed!
Our heat conducting plates are a big advantage over other coolers. These prevent heat from building up behind the cooler and ensure that the warm air can escape directly from the cooling area. They also help with installation in other vehicles and are factory - equipped with vibration-damping rubbers.

Plug & Play

Development turned out to be quite difficult and time-consuming until we got this monster under the front fairing. It was important to us that no noticeable changes to the frame or cladding had to be made during assembly. There is no need to make holders or find suitable screws. The cooler can be installed plug & play without much effort . The only thing that needs to be done without is the horn holder and the original headlight. A “tuning” headlight can help here.

Quality

All of our coolers are hand-welded from high-quality aluminum. Before shipping, each one of them was checked for leaks in a diving tank, under water, using compressed air. This means we can meet the highest quality standards and are happy about a 0% return rate .

Why a bigger cooler?

The optimal temperature of a 2-stroke engine is 55-60°. Anything outside of this range means loss of performance and/or increased wear. But be careful! If the outside temperature is too low or the engine performance is too low, it may be necessary to reduce the cooling performance, for example by masking it, in order to be back in the optimal range.

scope of delivery

-RPG grille
-2x holder
-2x vibration dampers
-All necessary screws and nuts

Dimensions: 350x206x45mm